x
Post
Consult
IM
Feedback
Top
Share
Glue Data
Basic performance:
E-881 AB epoxy resin glue can be cured at room temperature and heating. Its main properties are good leveling, fast natural defoaming, long yellowing resistance, bright surface without ripple, and the most important is high transparency.
1. High brightness and yellowing resistance.
2. High luminosity and flatness.
3. High solvent resistance
4. Self remove bubbles.
5. No pungent smell, harmless to human body.
| Project | Standard | |
| Appearance | A Glue | Transparent liquid |
| B Glue | Transparent liquid | |
| Viscosity(25C CPS) | A Glue viscosity | 6000 |
| B Glue viscosity | 200 | |
| Ratio | A Glue | 3 |
| B Glue | 1 | |
| Using time(25C 100g) | 45minutes | |
| Surface curing time(25C 2-3mmpieces) | 6hours | |
| Total dry(25C 2-3mmpieces) | 24hours | |
| Hardness(SHORED) | 85 | |
| Curing appearance | Smooth no bubble | |
| Hot deformation temperature C | 87 | |
| Tensile strength kg/cm2 | 30 | |
| Compressive strength kg/cm2 | 20-22 | |
| Shrinkage rate% | 0.2-0.6 | |
Storage and packaging:
This product needs to be sealed in a ventilated, cool, dry place, shelf life of 12 months, expired after the test qualified, can continue to use
Warm prompt
One: what reason is glue occurrence does not stick and do not cure?
Answer: this type of glue must be in accordance with its ratio, and it is the electronic weight ratio, not the volume ratio. Also, look at the temperature. If it's too cold, it's recommended to heat it up to 25 degrees before stirrig.
Second: we do not have vacuum equipment, how to defoaming?
Answer: dear, there is no vacuuming equipment no matter, our glue is natural defoaming, glue thoroughly after mixing, stationary 5-20 minutes, can automatically defoaming.
Three: why is our glue seven days old and still not solidified?
Answer: if the product is hard glue for 3 days and soft glue for 7 days and still does not cure, 1. Please check whether the ratio is based on weight; 2. 2. Whether the stirring method is correct or not. Considering environmental protection and safety, the curing agent is water-based, which is as thin as water. 3. If you can confirm that there is no problem with 1 and 2, then this is very important. The proportion of A component +B component of the primary glue should be more than 50 grams, and the proportion must be weighed by electrons.
Four: glue mix mix which component first pour?
Answer: when mixing this product, please pour glue B into the blender, and then pour glue A.
Five: I still don't understand what to do?
Answer: then please contact our customer service, we are ready to serve you 24 hours a day.
Verification Failed:
Verification Failed:
Comments
Feedback from Buyer